APCS Analiq

Automation parks storage

06

This system is a subset of APCS for storing and transferring of liquefied gases, ammonia and other corrosive, toxic, flammable, combustible or pressurized liquids in closed containers.

A typical block diagram is shown in Figure.

 

The main components of the system are:

  • Stationary levelmeter and analyzer ANALIQ-S, which is installed on each tank of the storage park, technological reservoir or reloading post for continuous measurement of level, temperature, density, determination of volume and other parameters of liquids.
  • Hardware-software complex ANALIQ-MS. The measurement data, alarm signals are transmitted to a computer, wireless microcontroller or other APCS devices.

Levelmeter ANALIQ-S may in some cases replace or duplicate level sensors. To create an automated process control systems for overload and safe storage of petroleum products and other liquids software ANALIQ-MS was developed.

It provides continuous survey of devices, convenient visualization of the process on a computer screen, formation of warning and alarm signals upon achievement of limit levels, data transfer to automated systems of commercial or technical accounting and other SCADA-systems, alarm and remote monitoring systems.

06 07 CТРУКТ СХЕМА

Ultrasonic levelmeters-analyzers
of liquids ANALIQ

An innovative measurement method allowed prompt determination of not only the level but also the type, density and mass of the analyzed liquid and other quality characteristics, such as the percentage of propane and butane in liquefied hydrocarbons and other fluids. All of that is performed without using expensive spectrum analyzers.

Portable and stationary levelmeters and analyzers of liquids ANALIQ are designed to automate technological processes that require non-contact, explosion proof, continuous or episodic measurement of level, temperature, volume, mass, density of petroleum products (including liquefied gas propane-butane, chlorine, ammonia), oils, alcohols, esters, alkalis, acids and other sound transmissive liquids in above-ground closed, sealed or pressurized reservoirs, mixing chambers, separators, fuel tanks, etc.

These devices are produced by our "subsidiary company" NPF "Ultrasonic Advanced Technologies" which involves developers and designers of "SRI Gidrobor". Fundamental knowledge in the field of hydroacoustics, electronics and modern microprocessor technology enabled the development of devices that operate based on the principle of ultrasonic echo-location of fluid through the walls of tanks, reservoirs, pipes, cylinders without any contact with the measured liquid or its vapors.

industry

applications

Petrochemical production

Chemical industry

Transport
and storage petroleum products, ammonia, liquefied gases

Power plants

Pharmaceutical industry

Manufacture
of food products

Brewing and winemaking

Railway

контакти

 

Аddress:
03151, Kyiv,
Ushinskogo st., 28, of. 311

On the map

Phone:
+38 044 243 00 14 
+38 044 243 00 18 (fax)
+ 38 067 323 95 30
+ 38 050 358 45 43